Series 5660 OEM roughness detector 


"Teachable" Detector Based on True False Principal


5 6 6 0 X                          
 

 

Surface Area to be Tested
    1 = 10 mm2 Surface area
  2 = 1 mm2 Surface Area
   
 
 
 
   
3D AutoCAD drawing of sensor (zipped)   -   DWG = [R13] [R14] [R2000]       DXF = [R13] [R14] [R2000]

Technical Data Description
Operating temp: - 20 ...+   60 degree C The roughness sensor has a built in infrared light source.  Scattered light reflected from a rough surface is analyzed and the roughness factor is compared to a master sample in the following way:

First, the detector is placed over a master sample and the button is pressed and held for three seconds.  The data is then stored or "taught" to the device.  Second, immediately  after the data has been stored, depress the same button again in short presses to set the tolerance.  Each press is equivalent to 0.2% tolerance.  The maximum tolerance is 3.2%.  There are 20 seconds to "calibrate" the detector.

Example:  To set the detector to sense a sheet of paper with a certain roughness from the master with a 1.2% tolerance.  The detector is placed on the sheet and the button is pressed for 3 seconds and released, then the button is pressed in short increments 6 times. (6 x 0.2 = 1.2)

- 04 ...+ 140 degree F
Weight:    6 oz (0.17 kg)
Protection: IP 54, NEMA 3
Housing: Die Cast Zinc Alloy
Humidity: Up to 98% permissible
Roughness range:  0.05 to 20 micron
Illumination:  890 nm
Data capture:  2 x 10 bit
Capture time:  5 msec
 
Connections
4 pole square connector
GND = GND
1 = Power Supply +11 ... 24 Volts, 100 mA consumption
2 = Push Pull output, High / Low, maximum 50 mA
3 = Push Pull output, High in tolerance field, maximum 50 mA
Output
Sample of Output
Part 1: Low out of Tolerance
Part 2: Low in Tolerance
Part 3: Hi in Tolerance
Part 4: Hi out of Tolerance
Dimensions
For a nominal charge of $100.00, Hohner Corp. will test and evaluate your samples to ensure this product meets your specific requirements and standards.  Should modifications be required, Hohner Corp. will advise in writing of any additional charges.

Cleaning of Device: Should be done regularly with a clean, dry, lint free cotton cloth.

The Life expectance of this device is 50,000 hours

 


1 800 295 5693 

UK   + 44 01978 363 888

BR   55 01938 775214