Series 4634 OEM roughness sensor with Analog output 4...20 mA

4 6 3 4                  
 

 
   
   

Scientific term: Scatterometer
   

Used for texture, imperfections, uniformity, seam and crack, glossiness and porosity
Buy online at Thomas Register  
3D AutoCAD drawing of sensor (zipped)   -   DWG = [R13] [R14] [R2000]       DXF = [R13] [R14] [R2000]
Technical Data Description
Operating temp: - 20 ...+   60 degree C The roughness sensor has a built in infrared light source.  Scattered light reflected from a rough surface is analyzed and the roughness factor is calculated in absolute or relative units. Some applications may need calibration.  Due to the sensitivity and high sample rates it is advised that the surface sensor be mounted firmly avoiding any environmental light.  The roughness sensor is a one dimensional instrument.  Circular movement over the probe changes measurement results.
- 04 ...+ 140 degree F
Current consumption: 50 mA (max.)
Weight:    6 oz (0.17 kg)
Protection: IP 54, NEMA 3
Housing: ABS chromed
Humidity: Up to 98% permissible
Illumination:  890 nm Comparative measurement mode
Analyzed surface area:  10 mm2 To hold a specific surface finish, the sensor output can be compared with a previously obtained one. This will provide monitoring of the surface roughness during a technological process. The previously obtained sensor output is taken on    a “template” surface that meets quality requirements.
Roughness range:  0.05 to 20 micron
Connections Below is a sample graph showing the sensor output versus the roughness factor.  Note that the output shown across is not typical and varies for different materials and machining processes.
6 ft cable
Color Function
Black GND
Red +15 ... 24 Volts
White output 4 ... 20 mA
Absolute measurement mode and calibration
For applications requiring absolute roughness measurement, the sensor output must be calibrated against samples of the same material and type of machining with known roughness factors.
Dimensions
For a nominal charge of $100.00, Hohner Corp. will test and evaluate your samples to ensure this product meets your specific requirements and standards.  Should modifications be required, Hohner Corp. will advise in writing of any additional charges.

Cleaning of Device: Should be done regularly with a clean, dry, lint free cotton cloth.

The Life expectance of this device is 50,000 hours

Two 1/4" holes 2-3/4" apart are for precision mounting with dowel pins.

 
1 800 295 5693 

UK   + 44 01978 363 888

BR   55 01938 775214