Series 7H60 OEM fluorescence or color meter for liquids
|
Series 7H60 OEM fluorescence or color meter for liquids |
|
"Teachable" Detector Based on True False Principal |
|
|
7 | H | 6 | 0 | X | |||||||||||||||||||||
| 1 = For Color detection | ||||||||||||||||||||||||||
| 2 = For Fluorescence detection | ||||||||||||||||||||||||||
|
3D AutoCAD drawing of sensor (zipped) - DWG = [R13] [R14] [R2000] DXF = [R13] [R14] [R2000] |
||||||||||||||||||||||||||
| Technical Data | Connections | ||
| Operating temp: | - 20 ...+ 60 degree C | 4 pole square connector | |
| - 04 ...+ 140 degree F | GND = GND | ||
| Weight: | 52.9 oz (1.5 kg) | 1 = Power Supply +11 ... 24 Volts, 100 mA consumption | |
| Protection: | IP 54, NEMA 3 | 2 = Push Pull output, High / Low, max 50 mA | |
| 3 = Push Pull output, High in tolerance field, max 50 mA | |||
| Housing: | Bronze |  |
|
| Humidity: | Up to 98% permissible | ||
| Capture time: | 10 m sec | ||
| Data capture: | 3 x 10 bit | ||
| Input aperture: | Diffuser 5mm dia | ||
| Description | |||
| The
Color Sensor measures color reflection coefficients of surfaces.
It has a built in Halogen light source.
The Fluorescence Sensor measures color reflection coefficients of surfaces. It has a built in UV light source. |
|||
| Spectral sensitivities are as follows: | |||
| Spectral range 420 .. 700 nm | |||
| Spectral response | |||
| Red - 420..530 nm | |||
| Green - 490-600 nm | |||
| Blue - 590-700 nm | |||
| Number of elements in the detector: 3 | |||
| Signal from each channel is processed by a 10-bit analog-to-digital converter. 2 high-low opto-coupled outputs can be activated | |||
|
First, the detector is placed over a master sample and the button is pressed and held for three seconds. The data is then stored or "taught" to the device. Second, immediately after the data has been stored, depress the same button again in short presses to set the tolerance. Each press is equivalent to 0.2% tolerance. The maximum tolerance is 3.2%. There are 20 seconds to "calibrate" the detector. Example: To set the detector to sense a sheet of paper with a certain red from the master with a 1.2% tolerance. The detector is placed on the sheet and the button is pressed for 3 seconds and released, then the button is pressed in short increments 6 times. (6 x 0.2 = 1.2) |
||
| Output | ||
 |
Sample of Output | |
| Part 1: Low out of Tolerance | ||
| Part 2: Low in Tolerance | ||
| Part 3: Hi in Tolerance | ||
| Part 4: Hi out of Tolerance | ||
| Dimensions | ||
 |
||
| For a
nominal charge of $100.00, Hohner Corp. will test and evaluate your
samples to ensure this product meets your specific requirements and
standards. Should modifications be required, Hohner Corp. will
advise in writing of any additional charges.
Cleaning of Device: Should be done regularly with a clean, dry, lint free cotton cloth. The Life expectance of this device is 100,000 hours |
||
| 1 800 295 5693 |
UK + 44 01978 363 888 |
BR 55 01938 775214 |
